ExamTopics 350-401 Snapshot

Question #: 512 Topic #: 1

827144

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 513 Topic #: 1

827145

Answers

Correct answer and vote data stay hidden until you click reveal.

A. If the local device fails to receive a hello from the active router for more than 5 seconds, it becomes the active router.
B. If a router with a higher IP address and same HSRP priority as the active router becomes available that router becomes the new active router 5 seconds later.
C. The virtual IP address of the HSRP group is 10.1.1.1.
D. The hello and hold timers are set to custom values.
E. The local device has a higher priority setting than the active router.

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 514 Topic #: 1

827146

Answers

Correct answer and vote data stay hidden until you click reveal.

A. R2(config)#interface Gi0/0 R2(config-if)#ip ospf cost 1
B. R1(config)#router ospf 1 R1(config-if)#network 172.20.0.0 0.0.0.255 area 1
C. R1(config)#router ospf 1 R1(config-router)#no passive-interface Gi0/0
D. R2(config)#router ospf 1 R2(config-router)#passive-interface Gi0/0

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 515 Topic #: 1

827147

Answers

Correct answer and vote data stay hidden until you click reveal.

A. BGP is not running on RouterCHI
B. There is a static route in RouterSF for 10.0.0.0/24
C. The route from RouterDAL has a lower MED
D. The Router-ID for Router DAL is lower than the Router-ID for RouterCHI

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 516 Topic #: 1

827148

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 517 Topic #: 1

827149

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 518 Topic #: 1

827150

Answers

Correct answer and vote data stay hidden until you click reveal.

A. When VRFs are used, ARP protocol must be enabled in each VRF.
B. The ping command must be executed in the global routing table.
C. Interface FastEthernet0/0 is configured in VRF CUST-A, so the ARP entry is also in that VRF.
D. When VRFs are used, ARP protocol is disabled in the global routing table.

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 519 Topic #: 1

827151

Answers

Correct answer and vote data stay hidden until you click reveal.

A. 43
B. 52
C. 60
D. 82

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 520 Topic #: 1

827152

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 521 Topic #: 1

827153

Answers

Correct answer and vote data stay hidden until you click reveal.

A. Deploy a Cisco DNA Spaces connector as a VM
B. Perform tethering with Cisco DNA Center
C. Replace the WLC with a cloud-based controller
D. Implement Cisco Mobility Services Engine

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 522 Topic #: 1

827154

Answers

Correct answer and vote data stay hidden until you click reveal.

A. It remains in err-disabled state until the errdisable recovery cause failed-port-state command is entered in the global configuration mode
B. It remains in err-disabled state until the no shutdown command is entered in the interface configuration mode
C. It remains in err-disabled state until the shutdown/no shutdown command is entered in the interface configuration mode
D. It remains in err-disabled state until the spanning-tree portfast bpduguard disable command is entered in the interface configuration mode.

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 523 Topic #: 1

827155

Answers

Correct answer and vote data stay hidden until you click reveal.

A. least privilege
B. fail-safe defaults
C. economy of mechanism
D. complete mediation

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 524 Topic #: 1

827156

Answers

Correct answer and vote data stay hidden until you click reveal.

A. Enable Aironet IE.
B. Enable passive client.
C. Disable AAA override.
D. Disable FlexConnect local switching.

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 525 Topic #: 1

827157

Answers

Correct answer and vote data stay hidden until you click reveal.

A. 04:19:01:05:2e:32
B. 05:5e:5c:ac:0c:32
C. 00:00:0c:07:ac:20
D. 00:5e:0c:07:ac:20

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 526 Topic #: 1

827158

Answers

Correct answer and vote data stay hidden until you click reveal.

A. WAN Edge
B. vBond
C. vManage
D. vAnalytics
E. vSmart

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 527 Topic #: 1

827159

Answers

Correct answer and vote data stay hidden until you click reveal.

A. The number of hops it takes to reach the authoritative time source
B. The amount of offset between the device clock and true time
C. The number of hops it takes to reach the primary time server
D. The amount of drift between the device clock and true time

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 528 Topic #: 1

827160

Answers

Correct answer and vote data stay hidden until you click reveal.

A. Apply the correct interface to this WLAN
B. Apply the changes this SSID
C. Select the PSK under authentication key management
D. Define the correct Radio Policy.

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 529 Topic #: 1

827161

Answers

Correct answer and vote data stay hidden until you click reveal.

A. custom
B. weighted-fair
C. FIFO
D. priority

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 530 Topic #: 1

827162

Answers

Correct answer and vote data stay hidden until you click reveal.

A. Users lose connectivity
B. Already connected users are unaffected but new users cannot connect
C. All devices reload after detecting loss of connection to Cisco DNA Center
D. User connectivity is unaffected
E. Cisco DNA Center is unable to collect monitoring data in Assurance

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 531 Topic #: 1

827163

Answers

Correct answer and vote data stay hidden until you click reveal.

A. configure switchport nonegotiate on SW1
B. configure switchport nonegotiate on SW2
C. configure switchport mode access on SW2
D. configure switchport mode trunk on SW2
E. configure switchport mode dynamic desirable on SW2

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 532 Topic #: 1

827164

Answers

Correct answer and vote data stay hidden until you click reveal.

A. Ensure that the "Connect even if this network is not broadcasting" option is selected.
B. Change the security type to WPA2-Personal AES.
C. Use the empty string as the hidden SSID network name.
D. Limit the enabled wireless channels on the laptop to the maximum channel range that is supported by the access points.

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 533 Topic #: 1

827165

Answers

Correct answer and vote data stay hidden until you click reveal.

A. RIB is derived from the control plane, and the FIB is derived from the RIB.
B. FIB is derived from the control plane, and the RIB is derived from the data plane.
C. RIB contains the interface for a destination, and the FIB contains the next hop information.
D. FIB contains routes learned through a dynamic routing protocol and the RIB contains routes that are static or directly connected.

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 534 Topic #: 1

827166

Answers

Correct answer and vote data stay hidden until you click reveal.

A. standardized data structure independent of the transport protocols
B. creation of transport protocols and their interaction with the OS
C. user access to interact directly with the CLI of the device to receive or modify network configurations
D. standardized data structure that can be used only with NETCONF or RESTCONF transport protocols

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 535 Topic #: 1

827167

Answers

Correct answer and vote data stay hidden until you click reveal.

A. economy of mechanism
B. complete mediation
C. separation of privilege
D. least common mechanism

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 536 Topic #: 1

827168

Answers

Correct answer and vote data stay hidden until you click reveal.

A. monitor session 11 type erspan-destination destination interface GigabitEthemet4 source erspan-id 11 ip address 10.10.10.10
B. monitor session 12 type erspan-destination destination interface GigabitEthernet4 source erspan-id 12 ip address 10.10.10.10
C. monitor session 11 type erspan-destination destination interface GigabitEthernet4 source erspan-id 12 ip address 10.100.10.10
D. monitor session 12 type erspan-destination destination interface GigabitEthernet4 source erspan-id 11 ip address 10.10.10.10

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 537 Topic #: 1

827169

Answers

Correct answer and vote data stay hidden until you click reveal.

A. The command succeeded in deleting the object.
B. The object was located at the URI, but it could not be deleted
C. The object could not be located at the URI path.
D. The URI was invalid.

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 538 Topic #: 1

827170

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 539 Topic #: 1

827171

Answers

Correct answer and vote data stay hidden until you click reveal.

A. RouterB(config)# router ospf 1 RouterB(config-router)# area 2 range 192.168.36.0 255.255.252.0
B. RouterB(config)# router ospf 1 RouterB(config-router)# network 192.168.38.0 255.255.255.0
C. RouterB(config)# router ospf 1 RouterB(config-router)# network 192.168.38.0 255.255.252.0
D. RouterB(config)# router ospf 1 RouterB(config-router)# area 2 range 192.168.36.0 255.255.255.0

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 540 Topic #: 1

827172

Discussions

Discussions hidden. Click reveal to view 1 linked thread.

Question #: 541 Topic #: 1

827173

Answers

Correct answer and vote data stay hidden until you click reveal.

A. 10
B. 15
C. 20
D. 25

Discussions

Discussions hidden. Click reveal to view 1 linked thread.